How to create this sine pad?

[SynthVirusFreak]

I am very new to Zebra 2.
I understand the basics of synthesis, however Zebra 2 is a different beast.
It is very difficult also since Zebra 2 can produce a variety of tones and sonics out of the same synth.

I attached a sine pad made in XPAND 2 (Preset Soft Pads- 8 Warmth) and want to know how close can Zebra 2 get to that sonic texture.

I know Zebra 2 can make sine pads obviously, but how SONICALLY can it get to that end result by itself?

Any help is appreciated thanks!

UPDATE: it is crazy how an audio forum does not allow MP3 or WAV attachements but the preset in question can be heard hear:



It is the beginning sound. The preset can be heard above if you need to hear it isolated

[JC_]

I'm not really familiar with sound design in Zebra yet but you should check out Joseph Hollo's soundsets http://www.kvraudio.com/forum/viewtopic ... 1&t=356672 - I think he has some stuff that would put you on track. He might even be able to point you in a specific direction if he sees this thread.

[hollo]

You can download all the 3 demo packs from this website to find many relative
colored pads. 

http://www.sound.artenuovo.com/padsheaven.html

Like "HeavenBells",
-Then tweak the Env1 and Env2 Attack to short (zero) and play around (lower) with the filter cutoff.
You can also change the waveform to a basic sine.

So just listen the presets and tear them apart

Cheers,
Joseph