Zebra HZ - breath mod matrix not working?

[thetechnobear]

hi.
Im using ZebraHZ rev 2570, and I'm having an issue with breath input on the mod matrix.

take the default patch, reduce sustain on env 1 to zero, and shorten decay
put in mod matrix, : breath, full mode, target ENV1:sustain.
it should then sustain the note if breath input, but it doesnt.

I can see midi data going into ZHZ from breath, also if I learn breath to XY i can see it.

if i switch over the mod matrix to aftertouch, or mod wheel it works as expected.
(even if the mod wheel event is generated by my breath pipe )

if i do exactly the same in Zebra2, it works as expected for breath

a known issue?

EDIT: i can also confirm breath works as expected on 2.6.1 REV 1593 of ZebraHZ

[EvilDragon]

Is that the latest rev available? This was an issue for Diva and Zebra at some point, but got fixed for rev 27xx or 28xx, I don't remember correctly.

[thetechnobear]

your right, was reported in August , against Zebra and ZebraHZ against 2570
http://www.kvraudio.com/forum/viewtopic ... Z#p5851333

whilst zebra was released, i don't see any notes that ZebraHZ was, however, I'm downloading now to see if I'm in luck

[thetechnobear]

nope I'm not in luck... i downloaded, and reinstalled its still 2570, I even retested in wild hope.
(I guess this is the problem with HZ now being part of the main release procedure.)

@Urs, any chance of a ZebraHZ with the fix included?
thanks
Mark