On some Cubase forums, I've often read about the ACPI or Standard Mode choice (something IRQ related I think) to gain performance on PC with W2K (and/or XP ?).
Does it matter for Tracktion ?
Is there a preferable mode or not ?
PC for T. : ACPI or Standard Mode ?
-
- KVRist
- 33 posts since 27 Oct, 2003
-
- KVRAF
- 4644 posts since 28 Nov, 2002 from Chicago
Ideally you should run with APCI enabled, as it is more efficient with resources.
Some people have had problems with APCI and found that reverting back to stamdard mode helped.
You cannot make the change on the fly though, you need to reinstall your OS after setting the interrupt mode.
FWIW, I use APCI and have no problems whatsoever.
Some people have had problems with APCI and found that reverting back to stamdard mode helped.
You cannot make the change on the fly though, you need to reinstall your OS after setting the interrupt mode.
FWIW, I use APCI and have no problems whatsoever.
Someone shot the food. Remember: don't shoot food!
-
- KVRAF
- 8103 posts since 13 Jan, 2003 from Darkest Kent, UK
just for the record...
ACPI Advanced Configuration and Power Interface
APCI Application-Layer Protocol Control Information
gets me everytime
.g
ACPI Advanced Configuration and Power Interface
APCI Application-Layer Protocol Control Information
gets me everytime
.g
-
- KVRAF
- 4644 posts since 28 Nov, 2002 from Chicago
In my defense, I'd only just woken up.
Someone shot the food. Remember: don't shoot food!