Mapping transport buttons?
-
- KVRer
- 10 posts since 19 May, 2014 from Urdorf Switzerland
Has anyone an idea how to map the transport buttons to a midikeyboard (axiom61). Is it possible to switch tracks in mulab from my midikeyboard? Does it need a specific mapping? Thanks for your advice!
-
- KVRAF
- 1925 posts since 29 Mar, 2013
Look at the docs page, more specifically the section about shortcuts, its fairly straightforward. Just select which function you want to control and press the relevant button on your keyboard. 
Beauty is only skin deep,
Ugliness, however, goes right the way through
Ugliness, however, goes right the way through
-
- KVRian
- 1352 posts since 17 Aug, 2012 from Old Zealand
Thanks for the heads up bibz1st. Sometimes I forget the first commandmentbibz1st wrote:Look at the docs page, more specifically the section about shortcuts, its fairly straightforward. Just select which function you want to control and press the relevant button on your keyboard.
in the computer bible: RTFM
NOTE (to others): When I assigned my RECORD button it was only active
as long as I pressed it down.
Then I opened the shortcut editor and right clicked my assignment
and chose: Change value 2 from 0-127 to 127-127.
Now it stays active until I press it again.
Same for Toggle loop.