I'm using Thesys to motion sequence and integrate my Volca boxes into my DAW and, for the most part, it works fine!
However, I'm facing the following two issues:
1st, the modulation sequencer resets the chosen MIDI controller target.
How to test:
1. Create a modulation sequence, choose any MIDI controller as the target (other than controller 1)
2. Switch to another pattern
3. Switch back to the previous pattern
4. Repeat 2 & 3 (not always necessary)
=> result: the target is reset back to controller 1.
2nd issue is that the controllers are offset by one, for instance to modulate CC40, one must choose controller 41 in Thesys. As minor as it sounds, this is an unnecessary thing to just have to remember to do every time.
Thesys v1.6.3, I tried both standalone and in Cubase Pro 8 on OS X 10.10.1.
Anyone else seeing this behavior?
Thesys resets target controller in modulation sequencer
-
- KVRist
- 97 posts since 3 Mar, 2003 from Tampere, Finland
-
- KVRist
- Topic Starter
- 97 posts since 3 Mar, 2003 from Tampere, Finland
