it would be nice if i could drag modules onto the wires and have it automatically connected in the middle.would save me a ton of time.
cheers!
(FR) drag and drop into wires
-
- KVRAF
- 13865 posts since 24 Jun, 2008 from Europe
Interesting suggestion, thx. Question: Imagine you drop a module on a audio wire, which has some edited properties like gain = -6 dB and pan is bit more to left, and the dropped module has both an audio in and out, then how should the existing wire be reconnected: To the input or to the output? Cause if it's applied to both the properties are applied twice then, both at in and out.
-
- KVRist
- Topic Starter
- 401 posts since 4 Nov, 2013
well it could go a couple of ways,i for one would have it applied to the input of the module,and not both. however you could have a feature that prompts the user on whether the wires edited properties should be before or after the module(then perhaps make it a preference to select if its always before or always after?) another way would be to divide the properties but that kinda sounds like it would be messy to code for no real benefit.
after thinking it over i feel the best way to go about it would be to have it normally go pre module, but press a hotkey like ctrl to make it post.maybe even another hotkey to make it the same on both ends like ctrl+shift.
after thinking it over i feel the best way to go about it would be to have it normally go pre module, but press a hotkey like ctrl to make it post.maybe even another hotkey to make it the same on both ends like ctrl+shift.
~Pyrotek45
-
- KVRAF
- 13865 posts since 24 Jun, 2008 from Europe