Step Sequencer problem

[ZentralmassivSound]

So I saw this (new?) feature, the "base on 0%" button. It seems to just toggle between 50% and 0% base. Would there be any way to adjust the base freely for each step?
Unfortunately the button isn't even in the documentation, nothing explained about this feature.

[MeldaProduction]

It's there for a long time actually. But you are probably trying to use it in a wrong way - it doesn't do anything to the actual values, it just changes the units, because for different places it may be a little confusing to use the other scale. Setting it for separate steps is therefore completelly useless.

[ZentralmassivSound]

It's there for a long time actually. But you are probably trying to use it in a wrong way - it doesn't do anything to the actual values, it just changes the units, because for different places it may be a little confusing to use the other scale. Setting it for separate steps is therefore completelly useless.

Hm I don't fully understand you reply to be honest. So you say it is just a visualization thing, not changing the step curve at all?

So, by default it is off. When I turn it on, all (curve form) steps I touch from that point on start at 50% rather than 0%. If it changes units, it would be better to change if for the whole graph so one has a consistent representation.

Anyway, what I thought it was, is that you can let curved steps start from somewhere non zero. Currently they all start from 0 and you can only modify the max value. It would be a cool feature if you could modify max and min values.

PS: and a short mention in the help box would be cool as well.

[MeldaProduction]

I'll check the help.
Anyway it really doesn't change the curve, just watch the output signal shape. It just changes the units, because sometimes 0..100 is better, sometimes -100..100, that's all . No marvelous feature here I'm afraid

[ZentralmassivSound]

I'll check the help.
Anyway it really doesn't change the curve, just watch the output signal shape. It just changes the units, because sometimes 0..100 is better, sometimes -100..100, that's all . No marvelous feature here I'm afraid

Well for the simple rectangle block it does not change the steps, but for the curved blocks it does.

Is that a bug then or a feature?

[MeldaProduction]

Hmmmm , well I need to check apparently it really does that damn now I feel a little stupid
Nice feature indeed