MeldaProduction

hprieger · Post by **hprieger** » Mon Jan 26, 2015 9:32 am

Hi,
I have the following question on the MDynamicEq:

Is each frequency dynamic when you load an instance of the plugin OR do you have to enable the dynamics in the settings menue for each band. In other words, do I first have to enable each dynamics setting for a band or are the bands already dynamic?

I am having trouble understanding this.

Gone soft · Post by **Gone soft** » Mon Jan 26, 2015 9:47 am

There's an "Enable" button for dynamics to be found if you rightclick the band in question. For me all of them are enabled by default, I see no reason why other peoples installs should be any different in regards to this. Though you will you have to define the amount of positive or negative "DYNAMICS" in the "DYNAMICS" department there, unless you've chosen some preset where amounts are allready defined offcourse.

hprieger · Post by **hprieger** » Mon Jan 26, 2015 10:00 am

Thanks, I understand that. My question was to undertand if the EQ already does dynamics on each band and/or if you have to enable them in the dymanics panel for it to work. I was unsure if the dynamics panel was kind of an Extra dynamic processing in addition to what the EQ does.

MeldaProduction · Post by **MeldaProduction** » Mon Jan 26, 2015 2:45 pm

No! Each band is static by default, unless you set the dynamic gain to something else than 0dB using the parameter or the vertical nodes.