I am trying to trigger a sample in MuSampla so that when I press the key again MuSampla cuts the previous sample and retriggers. Sort of like how you may set an MPC to monophonic or set a choke group to a sampler.
Everytime I replay the sample the previous sound overlaps and I can't figure out how to change this setting.
MuSampla Monophonic Mode One Voice Setting?
-
- KVRAF
- 13865 posts since 24 Jun, 2008 from Europe
Currently that's not yet supported by the MuSampla device, but there are alternative ways to do this:
1) You could use a MuSynth device and put the sample in the multisampler, then set MuSynth to monophonic.
2) Use a MUX Modular to build a sampler patch yourself. Easiest way is to start from the Basic Synth patch and then replace Osc1 and Osc2 by sample players modules. (or only Osc1 and delete Osc2). Then in the PolySynth -> Options -> Edit Polyphony -> set it to Mono.
Hope this helps.
1) You could use a MuSynth device and put the sample in the multisampler, then set MuSynth to monophonic.
2) Use a MUX Modular to build a sampler patch yourself. Easiest way is to start from the Basic Synth patch and then replace Osc1 and Osc2 by sample players modules. (or only Osc1 and delete Osc2). Then in the PolySynth -> Options -> Edit Polyphony -> set it to Mono.
Hope this helps.