Need Distortion/Drive

[diaper@ky]

Absolutely enjoy the 2 x Rotary plug ins I bought.

However I used a B3/147 combo way back when and only in the last few years found some acceptable replacements like the VB3.
Don't like their 3D sounding Rotary, don't like their Distortion.
Also don't really like the Drive in the 2 x Rotary plug ins.

I have great Distortion plug ins in Scope DSP but sadly that places them after the Rotary.
Really need something Post VB3, and Pre MRotary.

My beef is I can't get the right tones evenly up and down the keyboard.
When the upper registers sound pretty close the low end just overwhelms them.
On the original B3 I could always hold a low note then play high notes as the intro to Hold Your Head up by Argent, or Tarkus by ELP. You could hear the left and right hands equally.

Which Melda dist/drive plug would fit in between the VB3 and Rotary and best suit my tastes...?

Thanks, figure I'd stick with Melda as the Rotary's sound too good to go back to VB3 or the B2003 audio ins.

Thanks

[diaper@ky]

Jeez.........I better stop whining about a lack of hardware and stay with the few Native cats I been buying synths and FX from.
The Multiband Saturator dialed things in nicely.

Just because there isn't hardware for things doesn't mean Native can't do it..

Just an old hardware cowboy trying to stay in his new software Saddle...

SOLD.......

[MeldaProduction]

Hehe, so it is all fine, correct? I'm glad you like it!

[diaper@ky]

Perfectly too.
Every tone I remember and the Scanner Vibrato and Drawbars still come through without out of control and unequal distortion spanning the keys.

I really like this new light weight gear you are selling...

[MeldaProduction]

Very well, thank you!