Is there some way to force ZebraHZ to recall which order I have my modules in the rack?
For example, I like to have them set out in a logical way like this;
OSC1
OSC2
OSC3
VCF1
VCF2
etc.
So I organize them like that but when I close the window and open it again it changes everything in the rack to something like;
OSC2
OSC1
VCF1
OSC3
VCF2
etc.
It only affects the rack, in the grid each module stays in the same order. It's a minor problem but it can get rather confusing with larger patches and it's something that's seem to have come up after I updated to 2.7, I don't think I had this problem with 2.6 IIRC. Ideally I'd like the rack to reflect the order I have everything in the grid (if that makes sense), is this possible?
I'm using Ableton Live 9 if that matters.
Force Zebra to remember module order?
-
- KVRAF
- 4141 posts since 11 Aug, 2006 from Texas
As luck would have it we just discussed this a few weeks ago:
http://www.kvraudio.com/forum/viewtopic ... 1&t=436064
In short, there isn't a way to make the modules on the left mimic the ordering within the grid. There is a way to make the selected module rise to the top though.
http://www.kvraudio.com/forum/viewtopic ... 1&t=436064
In short, there isn't a way to make the modules on the left mimic the ordering within the grid. There is a way to make the selected module rise to the top though.
-
- KVRist
- Topic Starter
- 30 posts since 30 Oct, 2014
Ah, thanks for the link. I would've searched but I didn't know how to phrase it.
That's a shame, not a deal breaker though - selected on top is fine. As long as the signal chain isn't affected I guess that's all that really matters.
That's a shame, not a deal breaker though - selected on top is fine. As long as the signal chain isn't affected I guess that's all that really matters.