MeldaProduction

Fender19 · Post by **Fender19** » Tue Apr 28, 2015 2:57 am

Woah - something went wrong on this latest version of MDynamicEQ. When used in "logarithmic" mode the envelope detector is WAY over compressing. Sounds terrible, pumpy, surging. Even with Hold all the way to zero (to emulate the original level detectors) it's still not right. It seems something went wrong when they added the new RMS and Hold parameters.

MeldaProduction · Post by **MeldaProduction** » Tue Apr 28, 2015 2:30 pm

You contacted me via email as well, right? I just checked all of the modes and everything seems to be fine. Please send me some short dry loop and equalizer settings, ideally a simple project in your host (ideally Reaper).

mesaone · Post by **mesaone** » Thu Apr 30, 2015 7:16 pm

For my own info, where are these settings located? Is this the peak hold setting in the follower mode window, and mode setting Advanced window for the modulator follower mode settings?

MeldaProduction · Post by **MeldaProduction** » Thu Apr 30, 2015 10:21 pm

It's not in V9 in band settings

. By default 2ms both hold and rms I think. This seems to minimize distortion.

mesaone · Post by **mesaone** » Thu Apr 30, 2015 10:24 pm

MeldaProduction wrote:It's not in V9 in band settings ..

Where is it?

MeldaProduction · Post by **MeldaProduction** » Thu Apr 30, 2015 10:51 pm

Right click on a band for example

mesaone · Post by **mesaone** » Thu Apr 30, 2015 11:29 pm

Ohhh. In band settings. I still don't see any logarithmic detector setting, that one lives in Band Advanced Settings.

I didn't intend to hijack the thread, I just want to understand the context of it.

MeldaProduction · Post by **MeldaProduction** » Fri May 01, 2015 11:55 am

that one is in advanced settings

- ctrl+right click on the band (or there's a button in Band settings for example).

MeldaProduction

KVR Audio

MDynamicEQ 8.10 - envelope detectors not right