Stuck MIDI Notes ?

[jradiacom]

Could someone verify/duplicate on their system? Am I doing something wrong? thanks

I have 3 tracks

track 1 houses a multitimbral VST with 2 instruments receiving on midi channels 1 & 2 respectively
track 2 midi clip assigned to Midi channel 1 output to track 1
track 3 midi clip assigned to Midi channel 2 output to track 1


loop <on>

press play all is fine
press stop, track 3 channel 2 midi note hangs (panic is only way to stop)


Loop <off>
no problem

I have placed a piz monitor in front of the vst to verify the stuck midi note.

*each midi clip must have a note occurring at the very 1st tick
** creating rack instances of VST on tracks 2 and 3 does not solve.

[jradiacom]

Version 5 and 6, Win 7

[jradiacom]

placing piz MidiStuckNoteKiller in front of the VST solves the problem

[jradiacom]

MidiStuckNoteKiller does not solve the problem after all. Loop mode with my stated setup does not work. Either I'm missing something, doing something wrong or this is a fundamental bug.

[dupont]

I also often get stuck notes within T6 in loop mode.
It depends on the plugin and happens on a random basis.

[jradiacom]

In my case, it happens prior to the plugin(Kontakt). I have verified the stuck midi note with a midi monitor in front of the plugin.

GOOD NEWS however. Placing piz MidiStuckNoteKiller before the plugin with POWER set to OFF within the midi fx itself(not disabled via Tracktion) works. FLAWLESSLY.

I have placed a midi monitor on either side of of the stuck note killer and can see that it adds the correct midi Note Off messages even in POWER OFF mode. If the Power is set to ON in the stuck note killer it causes problems at loop boundaries.

I will send a screenshot of my environment once I get it all named and routed appropriately using plugin instances and multi-outs.