Logic Pro X Can't Run new update

[KaptainKwok]

Been trying a few things to get Sylenth1 to run but have not been successful.

I am currently using Logic Pro X - 10.2 on Mac OS X 10.9.5.

I keep getting this message whenever I open logic:

"An error has occurred with an installed Audio Unit plug-in.
Logic Pro X unexpectedly quit while trying to use the Audio Unit “Sylenth1” by “LennarDigital”.
This plug-in may require an update."

My guess is that I need to open Sylenth1 within the DAW in order for it to update. But updating can only happen if I open it

Any help would be greatly appreciated.

[stardustmedia]

Others and me also realized that this combo 10.2 & 10.9.5 seems to be faulty. Just install the old version again and use a 32-bit-bridge, as before.

[Ruben(LD)]

Please try downloading the latest beta version from your license mail. We have just released an updated version which should fix the problem.

[NNevez]

I installed the new update and have had no luck.
Sylenth does not show up in Logic X, under Mavericks. I don´t get errors, it just does not show up.
After the Sylenth installation, when i open Logic, it does not scan for additional AUs.

I opened Live and the Sylenth VST does not show up either.
Everyone seems to have no problems, so this is most likely a Mavericks specific problem.

[KaptainKwok]

Thanks for the fast response!

I've downloaded the new update via e-mail still gives me the prompt:

"An error has occurred with an installed Audio Unit plug-in.
Logic Pro X unexpectedly quit while trying to use the Audio Unit “Sylenth1” by “LennarDigital”.
This plug-in may require an update."

[geronimo]

The Audio Unit version of this Beta work fine with Digital Performer 9.01 under Yosemite 10.10.5.
The old Librairies are compatibles . Super !

[Ruben(LD)]

Mavericks 10.9.5 & Logic Pro 10.2 cause problems, we're working on a update