Ok i put a VCF and let the cutoff be controlled by envelope 3 or 4, i set envelope 3 or 4 to quadric instead of V-slope and touch the cutoffcontroller again in the filter, the envelope shifts back to v-slope.
It behaves like a quadric, but looks like a v-slope.
Did i miss something here?
Zebra 2.7 possible GUI bug?
-
- u-he
- 30240 posts since 8 Aug, 2002 from Berlin
I don't quite understand. Do you have screenshots or something?
Could it be an accidental MIDI Learn?
Have you tried the latest beta?
Could it be an accidental MIDI Learn?
Have you tried the latest beta?
-
- KVRist
- Topic Starter
- 89 posts since 5 Aug, 2010
https://www.dropbox.com/s/eanxnfdvm9pw2 ... o.avi?dl=0
See this video plz, this was the latest zebra build downloaded from the forum, i have another older revision where i tested it.
See this video plz, this was the latest zebra build downloaded from the forum, i have another older revision where i tested it.
-
- KVRist
- Topic Starter
- 89 posts since 5 Aug, 2010
critza wrote:https://www.dropbox.com/s/eanxnfdvm9pw2 ... o.avi?dl=0
See this video plz, this was the latest zebra build downloaded from the forum, i have another older revision where i tested it.
Did you watch the video, and did you understand what i meant?
/Christer
-
- u-he
- 30240 posts since 8 Aug, 2002 from Berlin
Affirmative! - It's a little GUI bugette.
I'll check if we can fix it for this update, but it also shouldn't be a showstopper.
I'll check if we can fix it for this update, but it also shouldn't be a showstopper.