MeldaProduction

DarkStar · Post by **DarkStar** » Wed Sep 30, 2015 9:50 pm

In MAutoEqualiser I can see the graph curves for the audio before and after the equalisation. How do I get that same view in MAutoDynamicEq?

mesaone · Post by **mesaone** » Thu Oct 01, 2015 6:32 pm

I would like to know this, too.

MeldaProduction · Post by **MeldaProduction** » Thu Oct 01, 2015 7:59 pm

I'm afraid you cannot, sorry. I'm now thinking I would see a solution, will think about it...

DarkStar · Post by **DarkStar** » Thu Oct 01, 2015 9:34 pm

Thank you

astramistil · Post by **astramistil** » Sat Oct 03, 2015 2:29 am

A must have for sure!

mesaone · Post by **mesaone** » Fri Oct 16, 2015 11:10 pm

I haven't had time to install the new 9.11 update yet. I saw the following line in the changelog:

Analyzer in all equalizers and other processors allow displaying both input and output.

Is that implementation of this feature request?

MeldaProduction · Post by **MeldaProduction** » Sat Oct 17, 2015 12:15 pm

mesaone · Post by **mesaone** » Sat Oct 17, 2015 6:50 pm

Vojtech, you're the best. I can't think of ANY developer that sees a feature request on a forum, and implements it in a release two weeks later

astramistil · Post by **astramistil** » Sat Oct 17, 2015 6:56 pm

ericzang · Post by **ericzang** » Fri Oct 23, 2015 4:50 pm

Is this setting found in the Analyzer settings? I haven't found it yet. I'm using MDynamicEq. Thanks.

mesaone · Post by **mesaone** » Fri Oct 23, 2015 5:05 pm

ericzang wrote:Is this setting found in the Analyzer settings? I haven't found it yet. I'm using MDynamicEq. Thanks.

I'm not in front of it now, but if I recall correctly it should be in Analyzer Settings > Main Settings tab > Analysis section > Source

ericzang · Post by **ericzang** » Fri Oct 23, 2015 7:12 pm

Thanks, I checked MEqualizer and yes that's where it is. I understand now MDynamicEQ doesn't have this option.

MeldaProduction · Post by **MeldaProduction** » Fri Oct 23, 2015 8:36 pm

ericzang wrote:Thanks, I checked MEqualizer and yes that's where it is. I understand now MDynamicEQ doesn't have this option.

Sadly there's a bug in MDynamicEq. It works initially when you open the plugin, but stops working as soon as you open the analyzer settings. Shall be fixed.

Oliver.Lucas · Post by **Oliver.Lucas** » Wed Oct 28, 2015 9:28 pm

mesaone wrote:Vojtech, you're the best. I can't think of ANY developer that sees a feature request on a forum, and implements it in a release two weeks later

Melda plugs have turned into my favorite plugs for quite a while now.
I use them on EVERY session I do. Absolutely AMAZING work.

MeldaProduction · Post by **MeldaProduction** » Thu Oct 29, 2015 9:44 am

Thank you!!!

MeldaProduction

KVR Audio

Q "Before" and"After" in MAutoDynamicEq ?