u-he

sinkmusic · Post by **sinkmusic** » Mon Nov 02, 2015 10:50 pm

Hello
This question may soud dumb, but i just can't figure out if it is possible to actually view the LFO speed somewhere in Zebra ?
Of course, I know i can type a speed value, but i can see nearly everytinthing moving everywhere (envelope detector, pitch detector, etc), but not for the LFO : am i missing something obvious ?
Thank you in advance

Erkenfresh · Post by **Erkenfresh** » Mon Nov 02, 2015 11:16 pm

Add a ModMap to any parameter on your synth but leave the mod value set to 0. Now the ModMap appears. In that, set the source to the LFO you want to look at.

sinkmusic · Post by **sinkmusic** » Mon Nov 02, 2015 11:20 pm

Ok, thank you.
But there is no direct way to see the LFO speed without creating a modmap ?

EvilDragon · Post by **EvilDragon** » Tue Nov 03, 2015 7:54 am

sinkmusic · Post by **sinkmusic** » Tue Nov 03, 2015 8:22 am

Ok, thank you for the info.
I hope it will eventually happen in Z3.

u-he

KVR Audio

Z2 Lfo visualization