Hello,
I have discovered an issue with the link parameter in Hive. I use link all the time in order to automate the cutoff for both filters at once.
To reproduce the bug:
1. Open Hive
2. activate the link parameter
3. while GUI still open, add some automation points in your DAW
4. close Hive
In my case the bug occurs either righter after closing Hive, or when re-opening it.
I'm on Mac OS X El Capitan and use Bitwig Studio 1.3.5.
BTW, is this the right place to report bugs? Thank you.
Hive: buggy "link" parameter
-
FortunOfficial FortunOfficial https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=341835
- KVRist
- 93 posts since 19 Nov, 2014
-
- KVRAF
- 4811 posts since 21 Jan, 2008 from oO
so what is the actual issue with doing this? Does it unlink or does it not respond or..?
JamWide - a cross-platform Ninjam client for DAWs
-
FortunOfficial FortunOfficial https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=341835
- KVRist
- Topic Starter
- 93 posts since 19 Nov, 2014
Haha my fault. The bug is that it gets unlinked. After opening Hive again the link is switched to off.