About those two automations ...it are gain (volume ) for rack and fx in that rack.
Not clear how this is made: depend on type of controller ?
- they seems to be separated from the midi editor ( a problem if i want transfer this automation to the drone setup ( composer + mulab) ? how
If the automation is under the midi notes it could be copied and paste
The basic synth rack has also as "content" : a sustain pedal automation ..
I am lost with this.
Automations where to track down in project
-
- KVRAF
- 1925 posts since 29 Mar, 2013
One way is to do it the same as I showed in other post with animations.Yes, those two ..how to get this..i will look again
OK, in Mulab, open the Airtime demo, press the little triangle on the basic synth TRACK Now open the giant hall fx in the basic synth "RACK" We are going to add another automation lane using the same giant hall reverb.
Right click the basic synth "TRACK" header and select "Add Sub-Track"
see next post
You do not have the required permissions to view the files attached to this post.
Last edited by bibz1st on Sat Jan 02, 2016 1:38 pm, edited 1 time in total.
Beauty is only skin deep,
Ugliness, however, goes right the way through
Ugliness, however, goes right the way through
-
- KVRAF
- 1925 posts since 29 Mar, 2013
Now click and drag the "DECAY" parameter from the reverb
(make sure you drag the name or value, not the knob itself) and drop it onto the new automation lane/Sub Track you just created. You can now start automating that parameter, for now just drag copy and paste the automation from the lane above
(make sure you drag the name or value, not the knob itself) and drop it onto the new automation lane/Sub Track you just created. You can now start automating that parameter, for now just drag copy and paste the automation from the lane above
You do not have the required permissions to view the files attached to this post.
Beauty is only skin deep,
Ugliness, however, goes right the way through
Ugliness, however, goes right the way through
-
- KVRist
- Topic Starter
- 203 posts since 26 Sep, 2014
Yes good explained..you did it already earlier ..but it is the little triangle what collapse the automations lanes ( i was after this! )
Stupid i did not see that triangle ( i know the meaning ): that is why they become a rectangle without nothing on it written.
I will study you example again..thanks for that !
Next problem to set up is to get the full 6 midi channels on the Vst midi drone device ( i will show a pic of that ) in the session modular area
Stupid i did not see that triangle ( i know the meaning ): that is why they become a rectangle without nothing on it written.
I will study you example again..thanks for that !
Next problem to set up is to get the full 6 midi channels on the Vst midi drone device ( i will show a pic of that ) in the session modular area