KVR Audio

chk071 · Post by **chk071** » Sun Feb 28, 2016 3:32 pm

Okay, no problem.

Igro · Post by **Igro** » Sun Feb 28, 2016 3:38 pm

chk071 wrote:Okay, no problem.

Or just make an audio file and sent to me. make sure you keep it loud, aorund 0 db. Just one note, without release, just deacy. Use a sine wave. And give it time to decay properly. I will show you then screenshots.

chk071 · Post by **chk071** » Sun Feb 28, 2016 4:50 pm

Trying to setup a test at the moment, with Electra2 and the Saurus demo. Is there a way that the oscillators in Saurus create a pure sine wave? Don't see it as a choosable waveform in the osc section...

Igro · Post by **Igro** » Sun Feb 28, 2016 6:02 pm

chk071 wrote:Trying to setup a test at the moment, with Electra2 and the Saurus demo. Is there a way that the oscillators in Saurus create a pure sine wave? Don't see it as a choosable waveform in the osc section...

IIRC, Electra 2 has it. But if not, filtered square or organ waveforms would do the job even better.

db3 · Post by **db3** » Sun Feb 28, 2016 8:32 pm

chk071 wrote:Trying to setup a test at the moment, with Electra2 and the Saurus demo. Is there a way that the oscillators in Saurus create a pure sine wave? Don't see it as a choosable waveform in the osc section...

There's a Sine preset in the tutorial preset category. That shows the 4th wave as being the sine.

chk071 · Post by **chk071** » Sun Feb 28, 2016 8:35 pm

Thanks, unfortunately now i ran out of demo time, so i can't use it anymore anyway... :/

db3 · Post by **db3** » Sun Feb 28, 2016 8:37 pm

You can just reinsert it again to demo. I can set a release time of 22 seconds...with no audible gate

chk071 · Post by **chk071** » Sun Feb 28, 2016 8:40 pm

Oh... didn't know that... But yeah, same on Electra2. Don't know why Igro thinks that is the case.

Igro · Post by **Igro** » Sun Feb 28, 2016 8:42 pm

So here we go chk071. Thank you for your file! You won't see this in Zebra 2 or Dune2 at the same resolution.

chk071 · Post by **chk071** » Sun Feb 28, 2016 8:47 pm

Ok, but do you think that's really audible? I mean, i really have to maximize the view to make it appear like that. Looks a bit weird indeed though, even though i wonder why that would save CPU... no idea about DSP though.

db3 · Post by **db3** » Sun Feb 28, 2016 8:47 pm

Nobody's going to notice that at -42dB

Daags · Post by **Daags** » Sun Feb 28, 2016 8:51 pm

nobody's going to notice the cpu it's supposedly saving by not giving the full(er) decay. so (why not) give the full(er) decay.

Igro · Post by **Igro** » Sun Feb 28, 2016 8:58 pm

db3 wrote:Nobody's going to notice that at -42dB

But that's original signal. Then it goes through compressors, limiters and other dynamic processors.

recursive one · Post by **recursive one** » Sun Feb 28, 2016 8:59 pm

Mac of BIOnighT wrote:
https://soundcloud.com/macnight/icarus-teaser-01

Thanks for this. If I were to guess the synth playing this, I'd say it's Dune2 - the same kind of very clean and a bit characterless sound. Maybe punchier a bit, better presence. Surely, this piece doesn't sound like other tone2 synths (I'd say, it sounds better).

As regrards the music itself, it is very nice, I love it!

Igro · Post by **Igro** » Sun Feb 28, 2016 9:00 pm

chk071 wrote:Ok, but do you think that's really audible? I mean, i really have to maximize the view to make it appear like that. Looks a bit weird indeed though, even though i wonder why that would save CPU... no idea about DSP though.

I noticed it not by using wave editors, but using ears. But that is just me. It was important to me, when i did some minimal music.

Tone2 will release Icarus - 3D WaveTable Synthesizer