MMultiBandConvolution-Using just one IR weirdness.

[goldglob]

If I have an IR in filter slot A but nothing loaded in slot B and the (sensibly) greyed out Ratio has been previously set to anything but 100% A, the IR is not processed unless Serial Mode is on.
Would it be better if when just one slot is loaded, the Serial button is greyed out as well, and the IR is processed regardless of the previous Ratio setting.
In other words, with just one slot loaded, Serial/ Parallel should be irrelevant, and previously set Ratio should be irrelevant.
The current behaviour could be a trap if using the plugin for cab impulses rather than reverb because it won't be so obvious that the impulse is not actually working...I could be thinking " Hmmm, this supposedly incredible impulse doesn't seem to do much", not realizing that it is not actually being processed.

[MeldaProduction]

Well, there's not a reasonable solution really, since this actually implies you know what you were doing and suddenly you are not . I know it can be a little complicated to realize that, but still... not sure...

[goldglob]

Well, at first I didn't know what I was doing in that I was indeed thinking " Hmmm, this supposedly incredible impulse doesn't seem to do much", but then testing with obvious (long) reverbs I could see what was happening. So yes, was a bit complicated to figure this out . Not a problem once realized, but just thought it might be worth making it more logical so as to avoid this trap.

[MeldaProduction]

Yeah, well, I'll think about some reasonable solution, but it is a problem, just think of what happens if you don't load A...