TIP: File Browsing in Convolution Reverb

[DarkStar]

In MMultiBandConvultionReverb you can load impulse response audio files from anywhere. Sometimes the default file browser display is a bit small to see what's what. Now, you can, of course, make the plug-in GUI wider by dragging its edge.

Or:
(a) drag the divider between the two panes of the Browser
(b) collapse the waveform display temporarily so that the browser uses the while width of the Filters panel.

As in these screenshots.

>>> http://i.imgur.com/23RVVZg.png

In MXXXX, collapse the Modular Designer (the FX module grid) instead.

[vectorwarrior]

Ah, i didn't know you could collapse the waveform, that's helpful. Thanks!

[vectorwarrior]

One minor thing I noticed about this, the collapse button does NOT appear in MXXX's convolution. However, if you 'show in window' the convolutional, you can then see the 'collapse' button. Obviously it's a minor bug, Vojtech, any chance you can fix that? It's not super important but is inconsistent.

Convo.jpg

Also, is there any chance the file window can resize vertically to fit the space? It is very difficult to navigate with such a short file list.

Convo 2.jpg

Thanks!

[goldglob]

Just adding to that: notice that the collapse works separately for filters A and B, and that any resulting dead spots (from A, B, or both) are seen both in the popout and the normal screen.

[MeldaProduction]

I'll check about convolution in MXXX.

[vectorwarrior]

Thank you! It'll make my life a lot easier