MuTools

blahbah · Post by **blahbah** » Fri Apr 22, 2016 2:21 pm

Is there a way to enable/disable effects with automation?

Thanks.

MuTools · Post by **MuTools** » Fri Apr 22, 2016 2:33 pm

Not directly, but you could setup a bypass in mux using the Balancer 2 -> 1 and automate the balance parameter.

blahbah · Post by **blahbah** » Fri Apr 22, 2016 2:38 pm

Ok thanks, any plans to include a simple on/off automation feature in future versions?

MuTools · Post by **MuTools** » Fri Apr 22, 2016 2:46 pm

Can't answer that question atm.

sl23 · Post by **sl23** » Fri Apr 22, 2016 6:08 pm

I was looking at VengeanceSounds TapeStop effect and wondered myself if buttons could be added that were programmable just as MetaParam's are? Allowing simple on off states of many things that aren't yet available.

I wondered if something like TapeStop was a possibility in MuX? But without that button, the answer would be no.

sl23 · Post by **sl23** » Fri Apr 22, 2016 6:09 pm

double post

bibz1st · Post by **bibz1st** » Fri Apr 22, 2016 8:14 pm

sl23 wrote:I was looking at VengeanceSounds TapeStop effect and wondered myself if buttons could be added that were programmable just as MetaParam's are? Allowing simple on off states of many things that aren't yet available.

I wondered if something like TapeStop was a possibility in MuX? But without that button, the answer would be no.

Its possible to acheive on/off states with audio (red) and modulation (green) signals using something like...
http://www.kvraudio.com/forum/viewtopic ... 9&t=461261
to set the % to 0 or 100 very quickly if thats what you mean.

sl23 · Post by **sl23** » Fri Apr 22, 2016 8:44 pm

Thanks but no. I wanted to assign a button in Mux to a hardware controller to be able to use TapeStop function manually. It's a manual on off function where pressing the button is on and release is off.

bibz1st · Post by **bibz1st** » Fri Apr 22, 2016 8:59 pm

No worries

Taifunk · Post by **Taifunk** » Fri Apr 22, 2016 9:42 pm

sl23 wrote:Thanks but no. I wanted to assign a button in Mux to a hardware controller to be able to use TapeStop function manually. It's a manual on off function where pressing the button is on and release is off.

You mean a tape stop vst or mux patch?

sl23 · Post by **sl23** » Sat Apr 23, 2016 12:10 pm

Yeah, I looked at one by vengeance and wondered if a similar function were possible in Mulab. Without a configurable button though I doubt it can be done.

Taifunk · Post by **Taifunk** » Sat Apr 23, 2016 1:20 pm

I think you can make a tape stop effect in mulab using envelopes, delay, something else and for sure an note event pad used as a button.
I am not a great expert in making fx patch but someone more experienced than me could create a patch of this type.
Anyway there is a nice example in the factory library called "live effect" to see how this kind of effects work.
About the event pad used as a trigger/switch for the live effects attaching a simple example.

sl23 · Post by **sl23** » Sat Apr 23, 2016 7:11 pm

Cheers Taifunk, I'll take a look. Didn't think about using note event pad!

MuTools

KVR Audio

Effects on/off through automation