MeldaProduction

moonmadness · Post by **moonmadness** » Mon Apr 25, 2016 10:59 pm

it would be nice.

it's hard to tell what is what sometimes...

vectorwarrior · Post by **vectorwarrior** » Mon Apr 25, 2016 11:47 pm

There may well be other ways of doing this, but if you open up the analyser settings, go to 'graphs' and unclick color, then the input will remain colored but the output wont be. I'm not sure if that's a bug, but it'll get more differentiation.

Analyzer settings.jpg

Also, I generally just disable the input, it makes reading things a lot easier and personally I only care about the output. This is carried out on the 'main settings' page of the analyser settings.

steve2KVR · Post by **steve2KVR** » Tue Apr 26, 2016 1:22 am

++++++++++++++1KM

DarkStar · Post by **DarkStar** » Tue Apr 26, 2016 9:59 am

^^^
KM ?

--------------------
But +1 anyway to distinguish between input and output.

MeldaProduction · Post by **MeldaProduction** » Fri Apr 29, 2016 9:53 am

The problem is, other colors are often used for long term analyses etc... And the current situation nicely shows the difference between in the input and output.

steve2KVR · Post by **steve2KVR** » Fri Apr 29, 2016 3:27 pm

..."KM ?" == a "thousand mega somethings"...'cause it's the little things that count...as V! noted above, it might be tricky.../s~

MeldaProduction

KVR Audio

Different colors for Input and Output in Analyzer please