MRotary - Control speed?

[LGK_Dude]

I'm wondering if its possible to control the speed of MRotary, specifically instead of having to choose between slow and fast, if its possible to start slow, and increase it via automation to something inbetween slow and fast? I see the advanced tab for speed, but it just has the slow rate and fast rate, but I dont see a way to play it like you would with a knob where slow is on the left, fast on the right, and you can set the knob in the middle.

Basically I want to automate between 3 settings, slow speed at around 0.7hz, then slowly ramp up to a "Medium speed" at around 2k and ending at the fast speed at around 5k. Is this possible?

[DarkStar]

Yes, indeed

Set the slow rate that you want then automate that to increase as needed. No need to use the Fast rate at all. Or assign the slow rate to a Multiparameter and automate that.

Also, explore the [Advanced settings] and you can set the two rates there and the acceleration time

[LGK_Dude]

HAHA! OF COURSE!! Its so obvious - I feel like such an idiot now, lol!! Thank you!!

I will admit part of me liked the ability in the advance tab of setting the acceleration time, and then just automating the switch, but unfortunately I need to have 3 positions for this tune and I think your idea of automating just the slow rate will probably work better. It might be cool if I could set how many "destination speeds" I wanted and then set the acceleration time and switch between them, but perhaps thats overkill. Its just the acceleration time to me feels like what would happen on a real rotary as it takes time to get the momentum going.

[DarkStar]

^^^^
Have a look at 'Banks' mode in the Multiparameters; something like this?

>>> http://i.imgur.com/DeFmA0L.png

[LGK_Dude]

Oh cool!! Will give that a go as well. Thank you so much for your help!!! Really appreciate it.