Q: MDrummer outputs?

[DarkStar]

the default MDrummer with an adjustable number of output channels

How do I adjust the number? And how do I route the drum kit pieces to the different outputs?

-----------------------
Also, (buglet) in the Global settings the Wav Output directory is always displayed as the default (<use name>/Documents) even though I have selected another folder.

[DarkStar]

Found it - in the MDrummer Configuration - at first glance that looked like it was for the audio devices for MDrummer standalone so I ignored it, but you set the number of channels there.

And the internal routing is tucked away in the Drumset Editor / Advanced drum parameters / Channel

------------------------------
(buglet 2) every time after I run MDrummer Confguration and start MDrummer the window pops up to locate the drum library, even though I have not changed it (and the pop-up is positioned to the right folder too).

[MeldaProduction]

The buglet - yeah, it's probably because you didn't install MDrummer to the same location as the factory library... I'm eager to remove the everything except for the MDrummer1out and MDrummer16out plugins actually... but people want the standalone...

[DarkStar]

Yes, the drums library is on a different disk.

As for the number of outputs, perhaps I should stick with the 16out edition.

[MeldaProduction]

I'd recommended that for sure!

[goldglob]

... but people want the standalone...

Yep, beats a metronome...if I haven't played for a couple of days, 20 minutes with MD standalone and my chops are back.. quick and easy ..no need to open a DAW project..love it.