Can this be fixed please, it's very time consuming to work around the broken automation in Logic X.Sampleconstruct wrote:Macro automation in MXXX still doesn't work in Logic 10.2.3 - when setting Logic to Latch and moving a Macro it picks up the controller ID but it sticks to the initial position of the knob/slider no matter how you turn the knob/slider. This has been broken for months now.
All MeldaProduction effects and MPowerSynth updated to 10.00 and MAGC released.
-
Sampleconstruct Sampleconstruct https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=191286 - KVRAF
- 16779 posts since 12 Oct, 2008 from Here and there
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- Topic Starter
- 14339 posts since 15 Mar, 2008 from Czech republic
Hmmm, I'll check! Btw. does it do that only with multiparameters?
-
Sampleconstruct Sampleconstruct https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=191286
- KVRAF
- 16779 posts since 12 Oct, 2008 from Here and there
As I have only been using MXXXCore lately, I'll have to check again with other plugins, all multi-parameters in MXXX are broken, Logic picks up the controller ID when touching the knob in MXXX, but it's then stuck at 50% which doesn't even reflect the value in the MXXX interface.MeldaProduction wrote:Hmmm, I'll check! Btw. does it do that only with multiparameters?