Easy way to insert steps in lfo wave editor, extreme drum synth problems

[blahbah]

Is there an easier way to insert steps into the lfo wave editor without having to click and edit all the curves?

Also I'm having issues running Extreme Drum Synth vst, occasionally crashes mulab.

Thanks.

[pekbro]

Well ideally, if your using the curves correctly, point numbers should
be kept to a minimum via interpolation.

Other than that, how else would you do it? Dunno if you've ever tried to
numerically add points to a curve. If not, lemme tell you graphically is
the way to go. Unless your into engineering or mathematics anyway.



-Cheers

[blahbah]

Sorry I must not be explaining properly, what's the correct way to use the curves to setup steps?

[pekbro]

Well the different types of curves have different parameters for
creating steps across their ranges. So that depends on what you want to
do. I suggest modifying some existing presets to see how they work.

Generally, you can create symmetrical curves of any range with just two points.

Say you want to create a block wave, you would set the start and end points.
This is the curve's range. Then you would set the end point to block wave, with say
10 quarters, starting at quarter 2. That would create a 5 step symmetrical block wave
between the two points.

Hope this helps.

-Cheers