Fm operator ---->zero Hz

[gentleclockdivider]

Would be great if we could set an FM operator to 0 hz , carrier as a sine shaper

[Urs]

You can do that in Bazille (any osc) and ACE (LFO1)...

[Howard]

It's a bit of a complicated kludge, but it looks like Zebra's FMO can be forced down to 0Hz.
Or as near as dammit...

1) Set the FMO's 'KeyScale' to zero (centre)
2) Set the FMO 'Tune' to minimum
3) Modulate (-48.00) FMO Tune with a Mod Mixer
- set to 'sum modulations' and 'Key' modes
- turn Constant up to maximum
- select 'MMap1' for Mod1 as well as Mod2
- set both map values to maximum

[gentleclockdivider]

It's a bit of a complicated kludge, but it looks like Zebra's FMO can be forced down to 0Hz.
Or as near as dammit...

1) Set the FMO's 'KeyScale' to zero (centre)
2) Set the FMO 'Tune' to minimum
3) Modulate (-48.00) FMO Tune with a Mod Mixer
- set to 'sum modulations' and 'Key' modes
- turn Constant up to maximum
- select 'MMap1' for Mod1 as well as Mod2
- set both map values to maximum

Well thanks howard , the above trick did it but only when the fmo is set to mono mode

When the carrier is set to spread/poly mode it has a fixed pitch of 1306 Hz.

Play around with the mod mix constant parameter or play verry low notes ...some voices will play higher pitches ( depending on voice count ) .
I thik this is a side effect of the verry low pitch and spread parameter .