u-he

romano55 · Post by **romano55** » Wed Aug 17, 2016 2:44 pm

How do you get the lfo to start modulating after a while after playing a sample? I tried different settings with no luck.
What settings should I use to achieve that result? Thanks.

ere2learn · Post by **ere2learn** » Wed Aug 17, 2016 2:51 pm

Which synth/effect are you talking about?

whyterabbyt · Post by **whyterabbyt** » Wed Aug 17, 2016 2:52 pm

romano55 wrote:How do you get the lfo to start modulating after a while after playing a sample? I tried different settings with no luck.
What settings should I use to achieve that result? Thanks.

Turn the 'start modulating after a while' control.

Once we know what plugin you're talking about, though, there might be more specific advice.

romano55 · Post by **romano55** » Wed Aug 17, 2016 2:54 pm

Hive.

ere2learn · Post by **ere2learn** » Wed Aug 17, 2016 2:59 pm

You would have to use an envelope with some attack on the lfo depth in the mod section,

pdxindy · Post by **pdxindy** » Wed Aug 17, 2016 4:00 pm

If you are using the lfo in the matrix, you can also use the 'via' option.

romano55 · Post by **romano55** » Wed Aug 17, 2016 4:03 pm

Got it! This is what I was doing. What is the purpose of mod 1 and 2?

ere2learn · Post by **ere2learn** » Wed Aug 17, 2016 4:29 pm

By default,mod 1 is for the cutoff modulation on filter 1 & mod 2 the same for filter 2,but they can be used to modulate anything via the mod matrix

romano55 · Post by **romano55** » Wed Aug 17, 2016 7:04 pm

Is this possible? After the sound fades into a 1/4 note lfo can it finish with a 1/32 note effect?

ere2learn · Post by **ere2learn** » Wed Aug 17, 2016 7:28 pm

Sounds more like automation,you would do in your DAW.

The rate knob under LFO section can multiply the rate of the LFO,if you turn it up to 2 you'll get 16ths,turn it up to 3 & you'll get 32nds when the sync is set to ¼

romano55 · Post by **romano55** » Wed Aug 17, 2016 9:03 pm

Thanks.

ere2learn · Post by **ere2learn** » Wed Aug 17, 2016 9:14 pm

Had a go at it,

If you set the the depth to 60 in the mod matrix for the LFO rate,you'll get your 1/32.Then just fade in it like you did before with the envelopes

Howard · Post by **Howard** » Thu Aug 18, 2016 12:08 pm

Try the manual: Click on the u-he badge (top right of the Hive window) and select "user guide" from the menu, go into the Hive folder and open "Hive user guide.pdf".

u-he

KVR Audio

lfo modulation