I've been exploring MMBD and run across some things that have me puzzled.
1. The Delay times under Tap 1 and Tap 2 are limited to 500ms. In the "same" plugin that is within MPS' Effect Panel, Tap 1 and Tap 2 have limits of 10000ms.
2. I'm not sure if the correct formula is being used to reach the dotted note values in either MMBD or the delay included in MPS. For example, at 120BPM a dotted 1/8 note is delayed at 375ms according to the formula 60,000/120=500ms (ms per beat)
500*4=2000ms (ms per measure [assuming 4/4])
2000/8=250ms (ms per note [1/8])
250*1.5=375ms (ms per dotted note)
3. I don't understand what the Tuplet subdivision is meant to indicate (probably due to misinformation or ignorance). By my understanding a tuplet is used to indicate where ie. 3 quarter notes are played in the space that would normally (according to the time signature) allow for 2 quarter notes to be played. How is this used or calculated without making further determinations?
Thanks for the help!
werzel
MMultiBandDelay problem
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14339 posts since 15 Mar, 2008 from Czech republic
Ok so:
1. Backwards compatibility thing, cannot be changed.
2. Dotted 1/4 here is actually dotted 1/8, because triplets are faster than the original measure, so to keep it simple dotted follows the same rule.
3. Tuplets are like triplets, but instead of 3, there's 5
1. Backwards compatibility thing, cannot be changed.
2. Dotted 1/4 here is actually dotted 1/8, because triplets are faster than the original measure, so to keep it simple dotted follows the same rule.
3. Tuplets are like triplets, but instead of 3, there's 5
