Workstation-type setup for live performance (front panel questions)

[yul]

Hello!

I am playing around with M7 and MUX trying to get a live workstation type performance setup working.

My idea is having a project that would allow for :

1- making splits and assigning each zone a synth

2- assigning an arpeggiator OR a sequence to a zone (switching between)

I have been playing around a MUX and have made good progress but there are a few points I am hoping someone could assist with,

For the splits, I believe the keyranger would be the best module. Is there a way to manage the key ranges via the front panel?

For the arpeggiator/sequence, is there a way to "switch" between the two functions? I presently use sends for midi notes that will flow either through the step sequencer or thru a parallel arpeggiator. both going to the same target synth. I use the process on/off for the sends in the front panel. It works but's it's not ideal. A method for switching would be better IMO.

Thanks in advance for your help!

[MuTools]

For the splits, I believe the keyranger would be the best module. Is there a way to manage the key ranges via the front panel?

No, not atm.

For the arpeggiator/sequence, is there a way to "switch" between the two functions?

Not directly but maybe some trickery with a couple of Note Pads to send events to a Note Dispatcher. Just a draft idea.

[yul]

For the arpeggiator/sequence, is there a way to "switch" between the two functions?

Not directly but maybe some trickery with a couple of Note Pads to send events to a Note Dispatcher. Just a draft idea.[/quote]

I'll try thanks!!