The band gain was changed by MIDI note pitch (C-2 -> -4.80 dB, G8 => +6.04 dB, not the MIDI velocity of note #48
Bug , or have I missed something?
Q: MIDI Control - Notes
-
- KVRAF
- 10375 posts since 2 Sep, 2003 from Surrey, UK
With these settings:
The band gain was changed by MIDI note pitch (C-2 -> -4.80 dB, G8 => +6.04 dB, not the MIDI velocity of note #48
Bug , or have I missed something?
The band gain was changed by MIDI note pitch (C-2 -> -4.80 dB, G8 => +6.04 dB, not the MIDI velocity of note #48
Bug , or have I missed something?
Last edited by DarkStar on Tue Dec 15, 2020 11:13 pm, edited 3 times in total.
-
MeldaProduction MeldaProduction https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=176122 - KVRAF
- 14339 posts since 15 Mar, 2008 from Czech republic
That's correct, the Notes tab reacts to MIDI notes, not velocities. For velocities use Controllers tab, there's a virtual controller "Velocity (on)" (plus a few more).
-
- KVRAF
- Topic Starter
- 10375 posts since 2 Sep, 2003 from Surrey, UK
Ah ha. I now see this "Note defines the controller's target MIDI note. It is used only in On/off and Switch modes, which you can set using Mode parameter." Perhaps it should be greyed out if it is not usable fin the currently selected Mode?
Using Velocity on the Controllers tabs doesn't quite do it, as that is not note-specific. I was aiming to use a single note number with different velocities to control a parameter.
Using Velocity on the Controllers tabs doesn't quite do it, as that is not note-specific. I was aiming to use a single note number with different velocities to control a parameter.
- 'Notes' uses the MIDI note number to control the parameter (in linear mode)
- 'Controllers' with a controller selected uses the data value of that specific controller to control the parameter
- 'Controllers' with 'Velocity' selected uses the velocity of any MIDI note received -- 'Controllers' with a controller selected uses the data value of that specific controller to control the parameter