Have imported Thrillseeker into MULAB 7 but my Rack level strips shoot into the red and there is no sound.
If I switch the Mojo function off I can then use the 3 section EQ. I am using ASIO4all.
I have tried Thrillseeker on my other laptop and all works fine although I am using realtec instead of ASIO????
Thrillseekerxtc overloading MULAB
-
- KVRer
- 12 posts since 4 Dec, 2016
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
-
- KVRer
- Topic Starter
- 12 posts since 4 Dec, 2016
Have spent most of new years day trying to sort this. If I launch new project in MULAB without any tracks recorded and bring Thrillseeker into the MASTER rack the MULAB level meters go right to the top with no slider control effecting it. If I then switch off the MOJO section or OUTPUT section then I can use the EQ side of Thrillseeker. Its as though it is feeding back when I switch the MOJO function on irrespective of where I have the controls set?