Change LFO sync freq

[bibz1st]

This one shows the % instead if that's preferred, its also vital to zero the Amount of modulation as the LFO Frequency doesn't go absolute zero (wow, I sound like I know what I'm talking about)

[bibz1st]

Nice idea bibz1st!

I have a slightly different problem:
I'm working on a editor for my Nord Drum2 and the 0-Coast.
It's all fully Midi CC controllabe, so I use plenty of Midi Controller Generator Modules driven by a Constant Value Module from the front end. This is fine for the continuous paramter like frequency, but not so ideal for things with low amount of variations spread over the entire CC range. E.g. there are 7 filter types which change every 18.2 CC value (19, 37, ...).
Your 'exact' solution would be perfect, especially with the pads i can give names.
Unfortunately it does not work when directed to the Midi Controller Generator.

Any idea how to solve this?
My current solution is a front panel knob that is limited to 1..7 which is then amplified through several green cables to a 1..127 range. Kind of works but I like your idea better.

Thanks
Andreas

Sorry Andreas, I have not had a need to use those modules so know little about how to use them at the moment.
Are you saying you need a finer amount of values rather than the 0 - 127 that MIDI gives ?

[AndreasD]

Thanks bibz1st, I figured it out by myself.
Your solution works perfectly, when i replace the OP's LFO with a Controller Generator.
(technical details: It actually works without change, I was only too stupid to read the final output correctly. The CC values actually ramp up/down from a previous to a new exact value, which filled exactly the height of my event monitor, which made me believe nothing happend)

So, if there is interest in a Nord Drum 2 or Make Noise 0-Coast editor, I should be able to make one in a few days.

Thanks
Andreas

[bibz1st]

Excellent, glad you sorted it