Substituting dynamic for static Eq in MAutoDynamicEq

[jazz from hell]

After trying to figure it out for hours, I still have the following problem with the Mautodynamiceq:

If I use the 'swap gain and dynamic gain' button, the eq curve I worked on before (static eq) isn't matched at all in the result -- all the 'dynamic gain' values seem to low.
Am I doing anything wrong??

[vectorwarrior]

The gain will be the max amount of gain. So it's all about input levels at the different frequencies. You can change how the dynamic detection functions, so it can reach the max faster or more appropriately. There's an advanced settings I think that allows you to change from linear to squared to logarithmic, logarithmic is the most aggressive. Change it to this, then you'll find it's probably too aggressive and you'll have to adjust some other settings in the dynamic settings. Sorry I can't be more specific, not at a computer.

[jazz from hell]

Thank you!