I'm currently using Sylenth 3.0.2 but am watching a tutorial video from quite a while back which is on v2.2. I noticed in the tutorial which was explaining about the filter cut off, the center display showed the cut off in Hz and that it covered/displayed most of the frequency spectrum when he turned the knob.
While in Sylenth 3.0.2 it doesn't display Hz and only goes up to 10.000.
I assume this means that 10.000 would equal to 20kHz? But know at 10.000 the filter is fully open.
I get that this is all about using your ears, but after seeing the tutorial it got me thinking.
Thanks
2.2 cutoff in Hz, 3.0.2 cutoff doesn't diplay Hz and goes up to 10.000
-
- KVRian
- 1330 posts since 25 Sep, 2006
-
- KVRer
- Topic Starter
- 4 posts since 28 Sep, 2016
Thanks LennardLennard wrote:viewtopic.php?f=94&t=475591&p=6651397