u-he

kevinmcnasty · Post by **kevinmcnasty** » Tue Feb 21, 2017 6:26 pm

I've seen where people have dealt with this problem before but I've yet to come up with a solution for it. When I save OSC settings in Zebra 2, it doesn't save the wavetable only the name. Any help on this matter would be greatly appreciated

3ee · Post by **3ee** » Tue Feb 21, 2017 10:18 pm

Hmm, not sure I understand ... maybe cause I didn't have this problem before.

I guess you already tried renaming ..

kevinmcnasty · Post by **kevinmcnasty** » Wed Feb 22, 2017 12:31 am

Basically when I go to one of the Osc tab on the left and click "save osc settings", it doesn't save my custom waveshapes/wavetable at the bottom correctly so I have to redraw them every time i want to use it on another oscillator or patch. I rename them and they show up in the OSC browser box but when it loads they're all blank. Am I doing something wrong here?

bmrzycki · Post by **bmrzycki** » Wed Feb 22, 2017 4:58 am

This one's new to me too. The only thing I can think is if it's some sort of permissions problem and you're on Windows newer than 7.

If you are see if this thread helps.
http://www.kvraudio.com/forum/viewtopic ... 1&t=306890

kevinmcnasty · Post by **kevinmcnasty** » Wed Feb 22, 2017 8:42 am

After a long afternoon of trial and error I determined that my problem was that I've been running the VST3 version instead of VST2. Apparently I missed the "Vst3 Readme" that came with the installation files. Thanks Everyone!! :]

u-he

KVR Audio

Problem Saving Oscillators in Zebra 2