Hello,
I am currently using Cubase 9 Artist under Windows 10 64bit. Today i did the update of sylenth1(downloaded the .exe from the website and just installed it) , and only one preset in one track isn't woking as it did before. It sounds totally diffrent than before. But all other tracks with sylenth presets work perfectly fine.
I am looking forward for a solution.
Cheers, Cedist
track with preset sounds bad after update
-
- KVRian
- 1330 posts since 25 Sep, 2006
Hi,
There were some slight modifications soundwise since v2.x. The phase modulation has been corrected and negative volume modulation has been zeroed.
Most presets will still sound exactly the same, but if a preset uses heavy phase modulation or negative volume modulation, then it may sound differently.
To make sure everything sounds exactly the same as in v2.x, click MENU -> Open Data Folder. Then browse to Config and open the Settings.xml file. Change the following line as such:
<UseV2Engine enabled="1"/>
Then save it and restart Sylenth1.
There were some slight modifications soundwise since v2.x. The phase modulation has been corrected and negative volume modulation has been zeroed.
Most presets will still sound exactly the same, but if a preset uses heavy phase modulation or negative volume modulation, then it may sound differently.
To make sure everything sounds exactly the same as in v2.x, click MENU -> Open Data Folder. Then browse to Config and open the Settings.xml file. Change the following line as such:
<UseV2Engine enabled="1"/>
Then save it and restart Sylenth1.
