Hi Jo,
is there a way to increase the range of the resize pointer in the part editor...?
Atm, I have to zoom in up to nearly 4 bars to be able to resize a sixteenth note event, even if on my monitor at an eight bar zoom it would be clear enough where the mouse pointer is (at the middle or at the end of the note event)...
For me the settings how it is now, is a bit too safe and causes sometimes a lot of zoom in and out...
Finetune request... :-)
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
Are you using a GUI Scaling higher than 100%?
If yes than indeed that aspect is not yet GUI Scale aware, but it is in the next version.
If yes than indeed that aspect is not yet GUI Scale aware, but it is in the next version.
-
- KVRAF
- Topic Starter
- 5070 posts since 27 Jul, 2004
No, I use standard scaling...
That´s what it looks like on my screen at 8 bar zoom... if I go over the right edge with my mouse cursor, I feel still enough detail to see, if I point in the middle of the event or at the edge... but Mulab doesn´t let me
That´s what it looks like on my screen at 8 bar zoom... if I go over the right edge with my mouse cursor, I feel still enough detail to see, if I point in the middle of the event or at the edge... but Mulab doesn´t let me
You do not have the required permissions to view the files attached to this post.
-
- KVRAF
- 13863 posts since 24 Jun, 2008 from Europe
