Tracktion Software

poshook · Post by **poshook** » Sun Apr 30, 2017 6:05 am

I installed Melodyne essential I got with Waveform purchase. I installed both AU and VST version and activated it via Celemony site. When I select Melodyne in Loop Properties I can see "Melodyne" label on audio clip in arrangement view. Pressing that label does not open Melodyne editor, it does not do anything. Any advice?

aMUSEd · Post by **aMUSEd** » Sun Apr 30, 2017 8:41 am

You need to install the VST3 version

magicmusic · Post by **magicmusic** » Sun Apr 30, 2017 5:28 pm

I download the demo of waveform it should have melodyne. as far i understand the 99$ version of waveform have melodyne too. but there is no entry for melodyne only elastique stretch modes. how can get this work in demo ?

jabe · Post by **jabe** » Sun Apr 30, 2017 6:45 pm

magicmusic wrote:I download the demo of waveform it should have melodyne. as far i understand the 99$ version of waveform have melodyne too. but there is no entry for melodyne only elastique stretch modes. how can get this work in demo ?

It's not part of the demo. If you buy Waveform, you should get details about downloading Melodyne Essential from the Celemony site.

You can get a 30-day trial of Melodyne from the Celemony site. I believe it's the full studio version, however, and not Essential.

http://www.celemony.com/en/trial

TSC · Post by **TSC** » Tue May 02, 2017 11:28 pm

Hey guys - when you make a purchase, you should receive an email from us with instructions and a unique Melodyne serial number - this is used on the Celemony site to get your free copy

If you don't see the email, be sure to check your SPAM filter as this type of automated message can get trapped

If you still cannot see it, ping our support team and they can resend: support@tracktion.com

poshook · Post by **poshook** » Wed May 03, 2017 9:37 pm

aMUSEd wrote:You need to install the VST3 version

This helped. Thank you

zzz00m · Post by **zzz00m** » Fri May 05, 2017 9:18 pm

poshook wrote:
aMUSEd wrote:You need to install the VST3 version
This helped. Thank you

On my system I already had the VST2 and VST3 installed. In this case Waveform defaulted to the VST2, which would not open up in Waveform.

I had to go to VST settings and disable the VST2 so that Waveform could use the VST3. That worked great!

nitex · Post by **nitex** » Sat May 13, 2017 5:54 pm

Easy to overlook, but in case you switched from 32bit to 64bit Tracktion, make sure the VST3 scan path is pointing to the right folder "C:\Program Files\..." and not "C:\Program Files (x86)\...".

Tracktion Software

KVR Audio

Melodyne essential installed but not available in Waveform