Please forgive me if this is obvious. I have a Behringer mixer with a USB 2 interface and Tracktion 5 on a Windows 10 PC. The mixer only outputs the stereo mix, except, by panning some inputs left and others right I can effectively get two mono tracks.
So here's the question, I can't see how to map the stereo channels to different tracks, is this possible and if it is, how?
Thanks.
Newbie question USB stereo to individual tracks
-
- KVRer
- 2 posts since 20 Jun, 2017
-
Peter Widdicombe Peter Widdicombe https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=336849
- KVRian
- 1214 posts since 29 Aug, 2014
On the audio interface which you see at the bottom after selecting it as input, the first radio dial is "treat as a stereo pair". Unselect that, and you then have to go back to select input, and you now have Input1 / Input 2.
I believe this setting stays this way until you go back and "treat as a stereo pair" again.
I believe this setting stays this way until you go back and "treat as a stereo pair" again.
Waveform 13; Win10 desktop/8 Gig; Win11 Laptop; MPK261; VFX+disfunctional ESQ-1
-
- KVRer
- Topic Starter
- 2 posts since 20 Jun, 2017
Hi Peter, Thanks for the help. It turned out to be not that straight forward due to Windows 10. Windows, bless its little cotton socks, decided the USB input was a mono microphone. Don't ask me why. It did, however, let me change it to a stereo input. The your instructions worked. Many thanks, Bryn