u-he

atmelcool · Post by **atmelcool** » Tue Jun 27, 2017 2:02 pm

Hello! Why in Zebra2 there is no possibility to assign switching presets from the controller? Will there be such an opportunity in Zebra 3? Thank you!

EvilDragon · Post by **EvilDragon** » Tue Jun 27, 2017 2:15 pm

Use the MIDI Programs folder along with Bank Select and Program Change messages. Read the manual on how to set it up.

atmelcool · Post by **atmelcool** » Wed Jun 28, 2017 10:23 am

Sorry, but I did not quite understand what you said ... could you explain in more detail? Thank you.

EvilDragon · Post by **EvilDragon** » Wed Jun 28, 2017 10:30 am

Zebra 2 manual, page 16, The MIDI Programs Folder section.

This is the only way you can use MIDI to change patches. Prev-next buttons are not and will not be MIDI assignable, because there are a lot of things that can go wrong depending on MIDI input vs hard disk access.

Urs · Post by **Urs** » Wed Jun 28, 2017 10:53 am

(cool, I hadn't known we had that in the manual... we might find a solution in future though...)

atmelcool · Post by **atmelcool** » Thu Jun 29, 2017 1:29 pm

This is not what I wanted, but thank you for your help! Urs will the zebra 3 switch presets from the midi controller? Thank you!

EvilDragon · Post by **EvilDragon** » Thu Jun 29, 2017 1:31 pm

I know it's not what you wanted but it's the only way to switch presets from MIDI controller that currently exists.

atmelcool · Post by **atmelcool** » Sat Jul 01, 2017 5:22 pm

EvilDragon wrote:I know it's not what you wanted but it's the only way to switch presets from MIDI controller that currently exists.

Thank you so much!

u-he

KVR Audio

Zebra2 next preset midi