Receptor Lockups

[DanTimis]

When I start Receptor, and load the first MULTI, it is arround 20-30%.

It peak to 100% for just a little moment, and come back to 20-30%... for 10 seconds, and peak again, etc...

It's something with usb_uhci error repport.

Bye
Spid

We will look into it.

Dan

[SoftJunkie]

bump

[Rick@MuseResearch]

Which Multi Bank and Patch are you loading? I'm looking into this. Can you provide the bank name and patch number?

When I start Receptor, and load the first MULTI, it is arround 20-30%.

It peak to 100% for just a little moment, and come back to 20-30%... for 10 seconds, and peak again, etc...

It's something with usb_uhci error repport.

Bye
Spid

[SpIdErWeB]

ie : With the first MULTI (synth, guit and voice).

Bye
Spid

[Rick@MuseResearch]

Open the SETUP window.
What is the Master Sample Rate and the Sample Buffer Size?

ie : With the first MULTI (synth, guit and voice).

Bye
Spid

[SpIdErWeB]

I remember 44.1 kHz and 128 for the size of buffer...

Bye
Spid

[Rick@MuseResearch]

I cannot duplicate the problem you are seeing; so far I have tested it on 4 different Receptors.

I have factory bank <Demo Multis> Patch 001: Keys, gtr, vox instantiated. Receptor is set to 44.1 / 128.

Does this happen when Receptor is idle or while it is processing MIDI and audio?
What is your Receptor Serial number?

I remember 44.1 kHz and 128 for the size of buffer...

Bye
Spid

[SoftJunkie]

SpIdErWeB,

do you have anything externally connected when this happens? for example, midi, ethernet, usb, ...

[Rick@MuseResearch]

I tried this with a network connected, not connected, iLok inserted and not inserted, sending MIDI notes and processing audio.

Does this happen all the time? Please try the following:
1. Power Receptor off for 15 minutes
2. Power up and see if problem starts up right away or when the Receptor heats up.
Note: Make sure the air ducts on the left and rear are not blocked.

SpIdErWeB,

do you have anything externally connected when this happens? for example, midi, ethernet, usb, ...