1. how can in turbo reverb reduce the dry level, when it is a ins effect 2. ignore beginning option

[magicmusic]

The global gain and all the volume settings change only reverb signal volume. reduce volume of dry is important that reverb get not too loud even if it have strong early reflections. then need dry signal reduce. and to compare reverbs better is better that all have simular loudness. in mconvolution this work with output gain and input gain. How can i change the level of dry signal too in turbo reverb ?

analyse IR have now a ignore beginning setting. because most impulses have a pre delay and the impulse i load in to test begin at 28 ms. I think it is more usefull when the impulse start at 0 ms and then i can set the predelay to 28 ms

I test to load in the impulse and set the ignore beginning setting to 882 samples. this should be 20 ms at 44.1 khz. so the impulse should then start at 8 ms. biut the impulse start at same time, it get only louder and sound diffrent

[MeldaProduction]

1) There's no way to change the input, you can only change the output level. Dry/wet handles everything and maintaines approximately the same loudness of the output, which is what is necessary for a fast workflow.

2) I don't follow, is there a problem?

[ElevatedBeing]

The global gain and all the volume settings change only reverb signal volume. reduce volume of dry is important that reverb get not too loud even if it have strong early reflections. then need dry signal reduce. and to compare reverbs better is better that all have simular loudness. in mconvolution this work with output gain and input gain. How can i change the level of dry signal too in turbo reverb ?

Use it as a send instead of an insert, should do the trick. Right?

[magicmusic]

when not possible to reduce dry signal then it is not possible that reverbs sound same loudness to easy try out diffrent reverbs. if wet level is for a reverb 30% wet then dry can be louder as if the reverb use 60% wet. so reverb effects mostly have slider to change dry signal.

to 2. please see screenshot. it can see that the impulse start at 28 ms. so i thought with this option i can reduce the init delay. and if i wish a delay, i can set it with delay slider.

[MeldaProduction]

1) Every reverb implements dry/wet differently anyways. I'd suggest using MCompare for that for example.

2) Click the Remove decay. The delay is an essential part of the original IR.

[magicmusic]

I mean with reverb test diffrent reverbs in turbo reverb. for example the preset small spaces Living room give max level with my sound of -2 db. when switch to preset small spaces Percussive Space then level only reach -5 db. and the loudness that is hear is much louder in Living room. so when have a input value as in mconvolution it is possible to reduce or increase the signal in same level in dry and wet so it fit good and give same loudness.

2. you mean remove delay. the remove delay work ok, thanks . BTW the online help have write error i think. that make it not so easy to understand. there stand "remove the empty space in from of the first tap". i think you mean "remove the empty space in front of the first tap" but you know, my english is not good

[MeldaProduction]

1) Try AGC. Note that reverb auditioning is always problematic. E.g. brain sort of dyslikes comparing short and long reverbs...

2) Aaaaha thanks!