Intent or bug?

[werzel]

While browsing through the presets in MCombMB (I need to pretend to be able to make a preset in order to access the exchange, so I am researching by looking at other presets) I noticed that any preset that has had the Meters added to the Easy Screen causes the Edit button to disengage. There are quite a few of these in MCombMB and scrolling through to see changes in parameters became a bit of a pain. Does the mere inclusion of meters warrant a shift to the Easy Screen even though there are no changeable parameters shown?

[jmg8]

I'm just looking for you now. But I can't seem to see any that have meters. Can you give me a name of a preset?

[werzel]

I began with the Root folder/ 1 band. Activate Edit. Use right arrow to move to the next preset (2 band). The Edit button deactivates and it shows the In, Side, Out meters and the Width meter. Click Edit to activate it. Repeat. Same results.

[jmg8]

OK I understand now.
So basically the state of the edit button is saved with the preset.
In this example I'm not sure it is good for the presets to default to the easy screen if there are no multiparameters.

Vojtech could you take a look at this one please?

[DarkStar]

As I understand it, the presets load in whatever view they were saved. Take one of those presets, change to Edit screen as save it as a new one.

[jmg8]

Correct. But that is a lot of work to put all the presets correct. As I see it there is no point in having the easy screen saved as default in the preset if there are no multiparameters.

[MeldaProduction]

Aaaaaha, that's probably because originally there was no easy screen. I'll try to fix that on application level.