Hi folks, question:
When using the 'gear porn' skin available in Bazille, I noticed that the Step Sequencer behaves slightly differently in terms of the default interval for the value of each step -- it moves by 2.5 instead of 2. I assume that's because the sequencer is smaller, graphically speaking, so more distance has to be covered as the slider moves...but that's just a guess.
Anyway, moving in increments of 2.5 isn't very helpful when programming pitch modulation, since 2 = one semitone. Meaning, it's much easier / faster to program pitch modulation in the Normal skin, because the increments line up to semitones. In 'gear porn' I have to keep doing the shift+drag to get to the right values, which takes considerably more time.
Ok, my natural question: is there any way to change the interval? e.g. so that it moves by 2 like on the normal skin, and not by 2.5? I really prefer the "all controls on one screen" UI of the GP skin, but am struggling too much with the Sequencer for pitch modulation, which I tend to do a lot of...
thanks!
-M
Bazille > GearPorn Skin > Step Sequencer Value Interval Default
-
- KVRAF
- 2430 posts since 11 Jan, 2009 from Portland, OR, USA
-
- KVRAF
- 24447 posts since 7 Jan, 2009 from Croatia
Use mousewheel on seq sliders and then they go up in 1.00 increments 
-
- KVRAF
- Topic Starter
- 2430 posts since 11 Jan, 2009 from Portland, OR, USA
EvilDragon wrote:Use mousewheel on seq sliders and then they go up in 1.00 increments
I'm on Mac with a Magic Mouse, but it should work the same way, I think? Surprised I didn't try that already, but I'll give it a go when I'm home..
-
- KVRAF
- 24447 posts since 7 Jan, 2009 from Croatia
Yeah whatever the scrolling motion is, should work, I think.
-
- KVRAF
- Topic Starter
- 2430 posts since 11 Jan, 2009 from Portland, OR, USA
EvilDragon wrote:Yeah whatever the scrolling motion is, should work, I think.
Sweet, thanks! I knew there was probably a stupidly obvious solution I hadn't thought of
