Hi,
I'm not sure what is going on here, seems that the LFO in Zebra is not working properly.
Both Polysynth and Zebra use init saw patch without any additional settings.
LFO are both on 1/1, but Zebra is doing very strange things
https://streamable.com/1imz0
Can someone reproduce it?
Zebra 2.8 LFO problems
-
tasmaniandevil tasmaniandevil https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=62450
- KVRAF
- 2171 posts since 22 Mar, 2005 from a planet called u-he
The LFO in Zebra is working correctly.
You are using the normal LFO module, which is per voice and will restart with each note you play.
From the manual:
You need to use the global LFO module (LFOG) in Zebra, which is not per voice and does not restart with each note.
Then you'll get the effect you want to achieve.
You are using the normal LFO module, which is per voice and will restart with each note you play.
From the manual:
That's what you hear.free: the LFO starts at a random position within its wave every time a note is played
You need to use the global LFO module (LFOG) in Zebra, which is not per voice and does not restart with each note.
Then you'll get the effect you want to achieve.
That QA guy from planet u-he.
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
with random phase unless RESTART is set to "gate", in which case it will start at the value of Phase.tasmaniandevil wrote:normal LFO module... is per voice and will restart with each note you play.
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
Actually the other way round: Vibrato is rigidly attached to LFO1. That's a feature.atmelcool wrote:In addition, LFO1 is rigidly attached to the vibrato