Hi all
Recently installed the KX Asio drivers for use on my Creative Audigy2 card. The latency is much better and also a better interface.
however experiencing a problem in Tracktion
Opened up Tracktion, and none of the audio INPUTS are present using the KX drivers. MIDI inputs/ outputs and audio outputs abound, but I don't see any audio inputs. I went to the KX control panel and unmutted the AC97 inputs for play and record which is where my inputs are. Rebooted Tracktion. reset devices..no go.
However opened up wave lab, and I can record fine from the an external input.
any idea? ( maybe I should contct the KX people too??)
Tim
No audio inputs using KX Asio drivers in Tracktion
-
- R.I.P.
- 3833 posts since 8 Sep, 2003 from Santa Clara, CA, USA
-
- R.I.P.
- Topic Starter
- 3833 posts since 8 Sep, 2003 from Santa Clara, CA, USA
tconrardy wrote:Hi all
Recently installed the KX Asio drivers for use on my Creative Audigy2 card. The latency is much better and also a better interface.
however experiencing a problem in Tracktion
Opened up Tracktion, and none of the audio INPUTS are present using the KX drivers. MIDI inputs/ outputs and audio outputs abound, but I don't see any audio inputs. I went to the KX control panel and unmutted the AC97 inputs for play and record which is where my inputs are. Rebooted Tracktion. reset devices..no go.
However opened up wave lab, and I can record fine from the an external input.
any idea? ( maybe I should contct the KX people too??)
Tim
Just a small update. I tried direct mode in Tracktion( not Asio) and the inputs show up there...very funny they don't show up under ASIO! HELP!
Tim
-
- R.I.P.
- Topic Starter
- 3833 posts since 8 Sep, 2003 from Santa Clara, CA, USA
OK......WOF WOF
I looked on the KX site at the knowlege base. I needed to set my sample rate to 4800, otherwise it won't record. I had it at 44.1
Did it, and the inputs showed up...what'ya know!
sorry guys...but maybe someone can use this info, you never know!
back in business..er..FUN!
TC
I looked on the KX site at the knowlege base. I needed to set my sample rate to 4800, otherwise it won't record. I had it at 44.1
Did it, and the inputs showed up...what'ya know!
sorry guys...but maybe someone can use this info, you never know!
back in business..er..FUN!
TC