ACE - rectify a signal?

[EvilDragon]

Use ramp?

[hakey]

The ramp's already being used to cycle the mapper.

[dlarseninclusive]

Here's the example patch for those screenshots:

Rectify.h2p.zip

VCA1 carries the original signal so you can compare.

You are totally 'Grand Master Jedi' I was studying half and full wave rectifier diode diagrams for a couple of hours last night trying to get the signal to offset. Only to see




**Respect**

[Howard]

FWIW, was trying to find a unipolar sawtooth to use as an envelope for pseudo sequencing with the mapper. Looks like that isn't possible.

Doesn't have to be unipolar to do that. You just have to read up about how to use bipolar modulation sources in the multiplex.

bipolar modulation example.h2p.zip

[hakey]

FWIW, was trying to find a unipolar sawtooth to use as an envelope for pseudo sequencing with the mapper. Looks like that isn't possible.

Doesn't have to be unipolar to do that.

I've lost the patch that prompted this, but it was a bit more complicated than that... it might have been modulation of the noise knob, which iirc, opens with both positive and negative values.

It's all moot as I've since realised that rectification of a sawtooth gives a DC triangle, not a DC sawtooth.

[Howard]

Although it's moot, see the example preset attached above. Bipolar mod sources have to be handled differently in the multiplex - you need to bridge the inputs and set the knob to 50%.

[hakey]

Thanks for the explanation, Howard.

Nice patch, too.

[Howard]

BTW for maximum percussion, try this...

Screen Shot 2018-02-15 at 14.53.53 .png

That LFO2 self-modulation shifts what would normally have to be 50% modulation depth in the multiplex up to about 70%.